The community around Raspberry Pi, Arduino & Co. grows and grows and so does the amount of ideas wanted to be realized with the great boards. Almost always one need a case at the end. Whether it is to protect the electronics or simply to get a more beautiful design and so one unavoidably run into following problems:

• The case doesn't fit for my board.
• The case can only cover one of my boards, but not my sensors, camera, storage media  and other electronic components.
• The case can only be used indoors.
• I can't get my cables with plugs (HDMI, USB, network) through the cable gland (so that it seals again at the end).
• I don't find a really nice case for outdoor.
• I can't find a enclosure solution that I can use over time.
• I can't find a enclosure solution that I can extend.
• I can't find a enclosure solution that fits for all my boards.
• …..

After 7 months of development we believe we have created a case system that will solve all these problems and provide a solid base for your future projects.

Check it out on Kickstarter - http://bit.ly/2QrUw0P

Hope to hear from you!
Feedback highly desired!